GT AUDI 4000 1986 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) (-) DRIVER'S PIN SWITCH
TrunkTrigger N/A
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights GRY/BLK L (+) AND GRY/RED R AT LIGHT SWITCH
Security
Parking Lights
ALSO (+) GRAY/RED-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition BLK (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/BLK + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety BRN/BLU (-) (-) GEAR SELECT SWITCH
Tach GRN/WHT (-) (-) OR GRN (-) AT COIL
SpeedSense WHT/BLU (AC) PIN A1 AT RADIO HARNESS
ParkingLights GRY/BLK L (+) AND GRY/RED R AT LIGHT SWITCH
BrakeLights RED/BLK (+) AT BRAKE SWITCH
ReverseLights BLU/RED (+) (+) AT SWITCH ON TRANSMISSION
Horn BLK/YEL (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock N/A ADD ACTUATOR IN DRIVER'S DOOR
PowerLock N/A ADD ACTUATOR IN DRIVER'S DOOR
Doorlocks / Windows
Power UnLock
ADD AN ACTUATOR
PowerLock
ADD AN ACTUATOR
Convenience
HeadLights YEL (+) (+) AT HEADLIGHT SWITCH
COUPE
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination BLU (+) RADIO HARNESS
Dimmer GRY/BLU (+) RADIO HARNESS
PowerAntenna WHT (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLK
FrontLeftSpeakerNeg BRN/WHT
FrontRightSpeakerPos GRN/BLK
FrontRightSpeakerNeg BROWN
RearLeftSpeakerPos WHT/BLK
RearLeftSpeakerNeg BRN/BLK
RearRightSpeakerPos GRN/BLK
RearRightSpeakerNeg BRN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
